Battery
When charging your Fly12 CE, the charge indicator LED (next to the charging port) will be solid red.
Once the battery is fully charged, this LED will become a solid green.
When your Fly12 CE battery is low (below 12%), the LEDs on the sides of the device will turn solid red and the low battery noise will play:
See HomeSafe mode (below) for more information.
Waterproof flap door open
If you leave the flap door covering the charging port and SD card slot open, the following sound will play to remind you to close the flap, ensuring the device remains waterproof.
Power on
The device will make a distinctive power up sound:
This will be immediately followed by up to four beeps to indicate battery level.
Four beeps indicates your battery is at least 75% full:
The Fly12 CE LED lights will be flashing green.
Three beeps indicate battery level of 50-75%:
The Fly12 CE LED lights will be flashing green.
Two beeps indicate battery level of 25-50%:
The Fly12 CE LED lights will be flashing orange.
One beep indicates battery level less than 25%:
The Fly12 CE LED lights will be flashing red.
Power off
The device will make a number of battery indicator beeps (as above) followed by a distinctive power down sound:
This sound is also heard when entering airplane mode and master reset.
Normal Recording
Recording alert is one short beep:
If enabled, recording alert beep plays once at an interval of 3, 5, or 10 minutes. This can be changed through the CycliqPlus mobile app; once your Fly12 CE is connected to your handset, go to menu - settings - sound.
No SD card/SD card error
If there is no SD card in your Fly12 CE or there is an error with your SD card, this sound will be played on repeat:
The LEDs on either side of the device will flash red and orange. The Fly12 CE will then automatically switch off after one minute.
Incident Protection Mode
When triggered, three rapid beeps will sound, indicating that the current and previous video files are locked, and can’t be overwritten by the device. These beeps sound like this:
The LEDs on either side of the device will flash red, orange and green. The Fly12 CE will then automatically switch off after 30 minutes.
HomeSafe Mode
When battery falls very low (below 12%), there will be three long beeps to indicate HomeSafe mode has been activated.
The recording will stop and, depending on your light settings, you have 30-60min to get home safely. While HomeSafe mode is enabled you will hear this sound every 1 minute:
Bike Alarm
With the bike alarm enabled, if your Fly12 CE is on the move, your device will sound the following alarm: