Please follow all the steps to ensure your camera doesn't separate from your bike during use.

Step 1: Installing the safety tether

On the back of the Fly6 CE are two rubber plugs covering the holes for the safety tether.

Push a pin or end of a paper clip through the open holes to loosen the plug and remove either the left or right plug.

Thread the thinner part of the tether through the hole, then thread the other end through the loop to secure the tether.

Reinstall the rubber plug back to the hole and push tightly.

Step 2: Mounting the camera to your bike

Insert the strap into the seatpost mount and pull all the way through to the buckle, this will ensure the strap is tight and secure.

Use appropriate rubber spacer for vertical mounting to your particular bike and attach it to the seatpost mount.

Strap the mount into your seatpost, make sure to tighten before fastening.

Insert your Fly6 CE at 10 o’clock position and turn clockwise to lock in.

Ready for your first ride? Check out Start Up and First Ride.